Tarkett Flooring Installation Instructions

If this measurement is less than 12 20 3cm the length of first plank in the row must be cut.

Tarkett flooring installation instructions.

Do not fasten them through the laminate flooring. Vinyl composition tile flooring. Check the rules in your country. Pvc or.

Install transition reduction profiles where needed. Do not use a hammer and tapping block to install planks. However there are a few exceptions. For installation room temperature should always be above 15 c or 18 c for linoleum.

In most cases you need to remove the existing floor covering. During installation inspect the groove area and remove any debris that may prevent proper assembly of planks. Remove your vinyl floor from its packaging and keep it in the room where it is to be. Tarkett will not accept responsibility for claims on flooring installed with obvious defects.

With the new 2 lock angle locking system parquet and laminate flooring have become very easy to install with only a few tools required. Tarkett laminate8 installation instructions 2 locktarkett laminate9 installation instructions 2 lock finish remove the spacers from the perimeter of the room. Measure distance between wall and surface of full plank. Those temperatures could be different.

These instructions combined with our adhesives and flooring products create a system. Tarkett flooring and adhesives must be site conditioned at room temperature for a minimum of 48 hours prior to during and after installation. Released may 2013 page 1 of 2 expressions vct inst 050713. The tongue side of the plank.

Before installation sheets and tiles should relax minimum 24h out of packaging. To get started you need to do the following. Rolls and tiles must be stored during 48 hours before starting the operation. Tarkett flooring may be installed over radiant heated floors provided the operating temperature does not exceed 85º f 29 4ºc.

The end joints of the planks in the first row. If the heating pipes are too close to the flooring the flooring may discolor next to the pipe work. Heating pipes shall be at least 2 inches 50 8mm below the surface of the concrete. Subtract 1 4 6 3mm or 1 2 12 7mm depending on the size of the spacer used from this measurement to allow for the spacer.

Do not install damaged planks. Installation begin laying planks from the left side of the starting wall and work to the right side. Room temperature must be maintained between 65 ｰ workmanship is employed in the and 85 ｰf 18 ｰ and 30 ｰc with hvac system operating. Ensure the subfloor is dry clean and flat.